• Springfield Armory M1 Garand, 1944 correct

    $0.00
    This item is out of stock

    Springfield Armory M1 Garand, 1944 correct

    nice correct SA M1 Garand, 1944 dated, see details below:

    Manufacturer : Springfield Armory Serial # : 2934880 Date MFR: Jun, 1944
    Receiver : D28291-34 Heat Lot : Y 09 C U
    Barrel : 1-SA-4-44 w/ "P" proof Top: D35448-31-Y-71-A-3, ord emb, M , B
    Bolt : D28287-12SA Heat Lot : S-A3
    Firing Pin : type 2, half round Extractor: parked Ejector: blued
    Operating Rod : curved side, D35382 9 SA, unmodified "M" top of handle, "P" top of cam
    Op Rod Catch : type 2 late, wide forks
    Bullet Guide : type 2 milled, unmarked
    Clip Latch : type 2 square front, unmarked
    Follower Assy : type 2, "12" marked
    Follower Arm : type 3 no bevel, w/o forge codes
    Follower Arm Pin : grooved, blued
    Follower Rod : type 5, long fork riveted
    Rear Sight : type 2, lock bar w/ round ends
    Sight Base : type 3, square cut Sight Cover : type 3, w/ ribs
    Windage Knob : knurled, SA closed arrows
    Elevation Knob : knurled, SA closed arrows
    Aperature : narrow w/ tracks Pinion : long 8-36
    Trigger Housing : small pad w/ cloverleaf hole, D28290-12-SA
    Trigger Guard : milled, unmarked, "T" inside center of guard
    Trigger : type 2, w/ forge codes
    Hammer : type 3, C46008-5 SA
    Spring Housing : parkerized Spring Plunger : type 2 square
    Safety : round top, SA-11 lower right
    Gas Cylinder : wide base, flat top rear ring
    Cylinder Lock : beveled top
    Lock Screw : poppit, cross slot "P" & triangle
    Front Sight : narrow ears, no screw seal
    Butt Stock : Springfield, "P" w/ serifs within circle, inside grip near bottom, faint 3/16" Ordnance stamp on bottom of grip. Cartouche : SA over GAW, small Ordnance stamp
    Butt Plate : standard trap type
    Stock Ferrule : large hole, stamped and brazed w/ "O" on inside
    Front Handguard : unmarked
    Lower Band : stamped and brazed, flat w/ solid pin
    Rear Handguard : w/ clearance cut
    Handguard Clip : stamped, flat
    NOTES : 75-80% finish, all components gage good.      
    Barrel bright w/ sharp lands and grooves. TE: 2.5, tight muzzle
    muzzle shows lots of bullet, throat measures #3 on a USGI gauge
    bore is nice and shiny, no issues